MODPORT I/O Module
- Shipping:
- Calculated at Checkout
Description
This product is used to extend I/O capabilities of the ComfilePi+CODESYS or as a companion to the ComfileHMI, but can also be used as a Modbus slave for any RS-485 Modbus capable application.
No programming required! Just connect a Modbus master via RS-485, set the Modbus slave address of each module, and it just works.
A wide variety of modules are available so you can configure your system specifically to your application's needs.
| MODEL | Description | Price |
| MD-H485 | RS485 Header Module | $19 |
| MD-DIDC8 | DC24V Input x 8 | $34 |
| MD-DOSO8 | DC Source Output x 8 | $39 |
| MD-DOSI8 | DC Sink Output x 8 | $39 |
| MD-DORL8 | Relay Output x 8 | $49 |
|
MD-ADIN4 |
13.3 bit AD Input x 4 0~10V, 1~5V, 4~20mA | $59 |
| MD-HADIN4 | 16.6bit AD Input x 4 0~10V, 1~5V, 4~20mA | $79 |
| MD-THRT4 | PT100 ohm (RTD) Input x 4 | $59 |
| MD-DAOUT2 | DA Output x 2 0~10V, 0~5V | $99 |
| MD-DAOUT2B | DA Output x 2 4~20mA, 0~20mA | $99 |
At least one slot board must be purchased separately.
Related Products
Related Products
5 Slot Board
$39.00
If your requirements only require five modules or less, the 5 slot extension board can be used independently as a main board.
Includes ribbon cable and terminator.
L03001
10 Slot Board
$59.00
The main module board comes in a 10 slot configuration. If 10 slots are insufficient, a 5-slot extension board can be connected to the 10-slot board to increase the capacity for additional modules...
L03002